Anti-Sweat Heater Controls: what works, and what works best?
Proven in the field. An independent Hannaford Supermarket study put it to the test: how do you cut anti-sweat heater energy without letting condensation cloud the glass? The AS‑20 answer saves about $10K-$38K per store per year in wasted door-heater electricity, with payback in under 24 months.
What every store recovers. The numbers behind every install
Inside the Hannaford anti-sweat heater controls study
An independent study. An independent study conducted at a Hannaford Supermarket set out to answer a question every grocery operator faces: with anti-sweat heater controls, what actually works - and what works best? The test compared the legacy approach (door-frame, glass, and mullion heaters running 24/7/365) against the AS‑20's dew-point-driven control across the same refrigerated glass display cases.
The methodology was simple and fair: hold condensation control constant - the glass must stay clear and product visible at all times, even on high-humidity days - then measure how much anti-sweat heater runtime each approach actually required. The AS‑20 held every door frame a safe margin above the dew point and proactively cycled heaters only when that margin began to close.
The finding: the AS‑20 didn't just beat the always-on baseline - it cut anti-sweat heater runtime far more than every other control method, including panel and relay systems, time schedules, and basic on/off controllers, all while never sacrificing condensation control. It's the clearest evidence yet that truly intelligent, case-by-case anti-sweat heater controls outperform every simpler approach.
This study informs measure #2 in our full ranking of supermarket refrigeration efficiency measures.

AS‑20 vs other anti-sweat heater control methods
How it compares. Most stores try to tame anti-sweat heaters with timers, relay panels, or basic on/off controllers. Here is how those approaches stack up against intelligent, case-by-case control.
| Control method | Energy cut | Condensation control | Per-case control | Monitoring & M&V | New network wiring |
|---|---|---|---|---|---|
| Always-on heaters (legacy) | None (baseline) | Always safe, always wasteful | No | No | N/A |
| Time schedules / timers | Low | Risk on humid days | No | No | Yes |
| Panel / relay systems | Low/Moderate | Risk; one bad door or case sacrifices ALL savings | No | No | Significant home-run wiring |
| ControlTec AS‑20 | 50-80% | Always protected, dew-point driven | Yes, every case | Yes, documented M&V | None (wireless mesh) |
In the Hannaford study, the AS‑20 cut anti-sweat heater runtime further than every other control method tested - without sacrificing condensation control.
Every kilowatt-hour is documented
Measured, never guessed. Because the AS‑20 monitors, tracks and records every reading, savings aren't projected - they're captured by built-in metering, ready for utility programs and ESG reporting.

- Energy waste eliminated
- Heaters run only when condensation is imminent - cutting runtime against the 24/7 baseline.
- Rebates captured
- Utility rebates can cover 10–100% of the project - prescriptive or custom measured-savings, paperwork handled by ControlTec.
- ESG impact logged
- Metric tons of CO₂e avoided, documented automatically for sustainability reporting.
Model your own per-store savings
Run your own numbers. Plug in your door count and energy rate to see projected savings, payback, and carbon avoided - per store.